Maytag Bravos MVWB850W Guida alla Manutenzione e Cura Pagina 11

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 10
11
WASHER MAINTENANCE
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this
recommended monthly cleaning procedure:
1. Make sure the washer is empty.
2. Using recommended AFFRESH
®
washer cleaner,
add one tablet to washer drum.
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN
WASHER with AFFRESH
cycle. Do not use more than
recommended amount of bleach to avoid damaging
product over time.
3. Close washer lid.
4. Press POWER/CANCEL.
5. Select CLEAN WASHER with AFFRESH
cycle.
6. Press START/PAUSE. Water will pour into washer
for a moment and pause, lid will lock, then cycle
will continue.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, press START/PAUSE twice and run a
RINSE AND SPIN cycle to ensure cleaner or bleach have
been rinsed from washer.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer’s nish,
do not use abrasive products.
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
WATER INLET HOSES
10. Press START/PAUSE to begin
wash cycle
Press the START/PAUSE button to start the wash cycle.
When the cycle has nished, the end of cycle signal will sound
(if set). Promptly remove garments when cycle is done to avoid
odor, reduce wrinkling, and rusting of metal hooks, zippers,
and snaps.
NOTE:
If you need to open the lid to add 1 or 2 missed garments,
you may do so while the Add a Garment indicator is lit.
PressSTART/PAUSE;thelidwillunlockoncethewasher
movement has stopped. This may take several minutes if the
load was spinning at high speed. Then close lid and press
START/PAUSE again to resume the cycle.
If lid is left open for more than 10 minutes, the water will
pump out.
9. Select cycle options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Clean Boost. These may be turned off,
if desired.
NOTE: Not all options are available with all cycles.
Vedere la pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Commenti su questo manuale

Nessun commento