Maytag MEDX6STBW Installation Manuale Utente

1W10646601A W10646602A-SPDRYER SAFETY ... 2INSTALLATION REQUIREMENTS ...

103-wire Power Supply Cord ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. A. 3-wire receptacle (NEMA typ

114-wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. Di

123-wire Direct Wire ConnectionUse where local codes permit connecting cabinet-ground conductor to neutral wire. B5. Remove center screwRemove center

13BCEConnect neutral ground wire and neutral wire2. Connect neutral ground wire (E) and neutral wire (white or center wire) (C) of power supply cord o

14Exhaust hoods: Must be at least 12" (305 mm) from ground or any object that may obstruct exhaust (such as owers, rocks, bushes, or snow).Elb

15The Vent System charts provides venting requirements that will help achieve best drying performance.Special provisions for mobile home installations

16Turn cold water faucet off and remove washer inlet hose.Remove old rubber washer from inlet hose and replace with new rubber washer. For non-steam

17Connect VentConnect vent to exhaust outlet1.Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent

18Tighten and adjust leveling legs2. If dryer is not level or the same height as the washer, prop up using a wood block. Use wrench to adjust legs up

19Lift door until top screws in dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer

2Dryer Safety

TroubleshootingSee the Use and Care Guide or visit our website and reference Frequently Asked Questions to possibly avoid the cost of a service call.C

3

4 Level Caulking gun and compound (for installing new exhaust vent)Parts needed: (Not supplied with dryer)Check local codes. Check existing electrical

5You will need: A location allowing for proper exhaust installation. See “Venting Requirements.” A separate 30 amp circuit. If you are using po

6Then choose a 4-wire power supply cord with ring or spade terminals and UL listed strain relief. The 4-wire power supply cord, at least 4 ft. (1.22

7Prepare dryer for leveling legs1. To avoid damaging oor, use a large at piece of cardboard from dryer carton; place under entire back edge of dryer

8Electrical ConnectionPower Supply CordElectrical Connection Options1. Choose electrical connection typePower supply cord 4-wire receptacle(NEMA Type

9Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain re